Brocade Communications Systems Brocade Network OS 2.1 Instrukcja Użytkownika Pobierz pdf (Strona 14)

4 Network OS Documentation Update

53-1002606-06

Chapter 23, Configuring LLDP

1. Log in to any switch in a Brocade VCS Fabric cluster.

2. In the global configuration mode, enter the interface command to select the RBridge/slot/port

for which you want to enable edge-loop detection.

3. In the interface configuration mode, enter the edge-loop-detection vlan command to specify

the VLAN you want ELD to monitor on this port.

If you do not specify a VLAN, the command fails.

4. Optional: Enter the edge-loop-detection port-priority command to specify the ELD port priority

of the specified port for the selected VLAN. Enabling switching is not mandatory when

assigning a port-priority.

Example

This example sets the ELD port priority on two port/VLAN pairs: port 1/0/7 VLAN 10 and port

4/0/6 VLAN 10. If both these ports are detected in the same loop, ELD shuts down port 4/0/6

when the pdu-rx-limit for the Brocade VCS Fabric cluster is reached. Port 4/0/6 is chosen for shut

down because it has been assigned the lower priority (higher number) then port 1/0/7.

(config)# interface TenGigabitEthernet 1/0/7

(conf-if-te-1/0/7)# edge-loop-detection vlan 10

(conf-if-te-1/0/7)# edge-loop-detection port-priority 5

(conf-if-te-1/0/7)# top

(config)# interface TenGigabitEthernet 4/0/6

(conf-if-te-1/0/7)# edge-loop-detection vlan 10

(conf-if-te-1/0/7)# edge-loop-detection port-priority 7

Chapter 23, Configuring LLDP

Delete the section titled “DCBX interaction with other vendor devices” on page 274.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Brak uwag

Brocade Communications Systems Brocade Network OS 2.1 Instrukcja Użytkownika Strona 14