Brocade Communications Systems Mobility 7131 Series Przewodnik Instalacji Pobierz pdf (Strona 23)

Mounting the Mobility 7131

Brocade Mobility 7131 Installation Guide - Dependent Mode 15

53-1001567-04

CAUTION

Brocade does not recommend mounting the Mobility 7131 directly to

any suspended ceiling tile with a thickness less than 12.7mm (0.5in.)

or a suspended ceiling tile with an unsupported span greater than

660mm (26in.). Brocade strongly recommends fitting the Mobility 7131

with a safety wire suitable for supporting the weight of the device. The

safety wire should be a standard ceiling suspension cable or equivalent

steel wire between 1.59mm (.062in.) and 2.5mm (.10in.)

in diameter.

The mounting hardware required to install the Mobility 7131 above a ceiling

consists of:

• Light pipe

• Badge for light pipe

• Decal for badge

• Safety wire (strongly recommended)

• Security cable (optional)

To install the Mobility 7131 above a ceiling:

1. If possible, remove the adjacent ceiling tile from its frame and place it aside.

2. If required, install a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in

diameter, in the ceiling space.

3. If required, install and attach a security cable to the Mobility 7131’s lock port.

4. Mark a point on the finished side of the tile where the light pipe is to be

located.

5. Create a light pipe path hole in the target position on the ceiling tile.

6. Use a drill to make a hole in the tile the approximate size of the Mobility 7131

LED light pipe.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Brak uwag

Brocade Communications Systems Mobility 7131 Series Przewodnik Instalacji Strona 23