Brocade Communications Systems MLX Series Przewodnik Instalacji Pobierz pdf (Strona 169)

Brocade MLX Series and NetIron XMR Hardware Installation Guide 155

53-1003267-02

Installing a NetIron XMR 8000 router

Before installing a module, have these items available:

• A large flat-blade screwdriver.

• An ESD wrist strap with a plug for connection to the ESD connector on the router.

DANGER

For safety reasons, the ESD wrist strap should contain a 1 megohm series resistor.

CAUTION

If you are hot-swapping a module, allow a minimum of two seconds after a module (or power

supply or fan tray) has been removed before inserting a module in the same slot.

Follow these steps to install a module in the NetIron XMR 8000 router.

1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on

the router chassis.

2. Remove the module from the packaging.

3. With the ejectors in the outward position, insert the module into the slot and slide the module

along the card guides until the ejectors rotate towards the faceplate of the module.

FIGURE 104 Installing a module in a NetIron XMR 8000 router

NOTE

When inserting the module into the router, make sure that the faceplate doesn’t overlap with

the faceplate of an adjacent interface module.

4. Rotate the ejectors flush with the module faceplate to fully seat the module in the backplane.

Modules have a snug fit for maximum EMI protection.

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 341 342

Brak uwag

Brocade Communications Systems MLX Series Przewodnik Instalacji Strona 169