Brocade Communications Systems MLX Series Przewodnik Instalacji Pobierz pdf (Strona 281)

Brocade MLX Series and NetIron XMR Hardware Installation Guide 267

53-1003267-02

Replacing an interface module

3. Reattach the cover plate using the two screws and screwdriver.

FIGURE 153 Inserting a compact flash card in the MR2 management module

Replacing an interface module

You can remove or replace interface modules while the router is powered on and running. For more

information on module slot locations, refer to Chapter 1, “Product Overview”.

NOTE

It is not recommended that you hot-swap an interface module that is running a software image older

or newer than the image on the management module. Although the management module will

attempt to sync the application image on the interface module, it may not be able to sync older FPGA

images. In this case the interface module may attempt to continuously reload. Always upgrade or

downgrade the FPGA images on replacement interface modules to match the software version on

the management module before you install the interface modules in your device.

For information about how to install a new or replacement module, refer to the installation chapter

for your router model.

CAUTION

If you are hot-swapping a component, allow a minimum of two seconds after a component has

been removed before inserting a replacement component in the same slot.

1 2 ... 276 277 278 279 280 281 282 283 284 285 286 ... 341 342

Brak uwag

Brocade Communications Systems MLX Series Przewodnik Instalacji Strona 281